beautypg.com

Altera LVDS SERDES Transmitter / Receiver User Manual

Page 21

background image

Option

Description

Use 'rx_dpll_enable' input port

Enables the path through the DPA circuitry. The option

supports dynamic, channel-by-channel control of the DPA

circuitry.
To enable the DPA circuitry for a channel, set the port for the

target channel to

1

. If this port is not used, the Quartus II

software enables all of the channels.

Use 'rx_dpll_hold' input port

Prevents the DPA circuitry from switching to a new clock

phase on the target channel. Each DPA block monitors the

phase of the incoming data stream continuously and selects a

new clock phase when needed. When this port is held high, the

selected channels hold their current phase setting.

Use 'rx_fifo_reset' input port

Resets the FIFO buffer between the DPA circuit and the data

alignment circuit. The FIFO buffer holds the data passing

between the DPA and the LVDS clock domains. When this port

is held high, the FIFOs in the selected channels are reset.
This option is available only if you turn off the Use 'rx_

divfwdclk' output port and bypass the DPA FIFO option.

DPA Settings 2 (page 6)
The options on this page are available when you turn on the DPA mode.
Use 'rx_reset' input port

Resets all components of the DPA circuit. You must retrain the

DPA circuit after this port resets the DPA circuitry.

Automatically reset the bit serial FIFO

when 'rx_dpa_locked' rises for the first

time

Specifies when the bit-serial FIFO resets for DPA circuit. This

option is only available in Stratix II, Arria GX, and HardCopy

II devices.

User explicitly resets the bit serial

FIFO through 'rx_reset'

When you turn on the

rx_reset

port, the ALTLVDS_RX

parameter editor allows you to choose whether or not to

automatically reset the bit-serial FIFO when

rx_dpa_locked

signal rises for the first time. This is a useful feature because it

keeps the synchronizer FIFO in reset until the DPA locks. This

option is only available in Stratix II, Arria GX, and HardCopy

II devices.

UG-MF9504

2014.12.15

ALTLVDS_RX Parameter Settings

21

LVDS SERDES Transmitter/Receiver IP Cores User Guide

Altera Corporation

Send Feedback