Echelon Lumewave CRD 3000 Street Light Bridge User Manual
Page 116

106
Interoperable Interface for the Street Light Bridge
Variable
Description
Ok to Modify?
nciPriRpt
Defines the repeat count for the
primary path.
Yes
See Defining the Networking
information about defining
channels.
nciSecChs
Defines channels for RF data
transmission on the secondary
(alternate) LonTalk (ISO/IEC
14908-3) path.
Valid values are 11 to 26. Values
outside this range are ignored.
Yes
See Defining the Networking
information about defining
channels.
Use 0 (zero) to indicate an unused
channel.
nciSecRpt
Contains the repeat count used for
the secondary path.
Yes
See Defining the Networking
information about defining
channels.
nciRepeatMode
Defines the Street Light Bridge
repeating type:
0 – normal repeating operation
(PL and RF)
1 – PL-PL repeating (no RF
transmission)
2 – RF-RF repeating (no PL
transmission)
Yes
See Defining Repeating on page 40
for information about setting the
repeat mode.
nciMediaAccess
Defines the power line media
access protocol:
0 – Default (media access protocol
is enabled during manufacturing,
based on the module model type)
1 – Normal (overrides firmware
setting and defines a PL-20N
channel)
2 – CENELEC (overrides firmware
setting and defines a PL-20C
channel)
Yes
See Defining the Media Access
Protocol on page 37 for information
about setting the media access
protocol.
Changes to this value take effect
only after a device resets.