Juniper Systems Archer Reference Guide - Manual (Page 47)

40
Resetting the device
Some programs require you to reset your device when you
install them. Follow the steps below to reset the Field PC:
1. Back up your fi les and close any open applications. (For
instructions on backing up fi les, see Backing up data in
this chapter.)
2. Press the power button until the power button menu
appears.
3. Choose Reset .
Note: If your device locks up, you can reset the device by pressing
the power button for 10 seconds or until the screen goes dark.
The device resets itself automatically after a few seconds.
Exploring fi les
To explore fi les stored on the Field PC, follow these steps:
1. Tap S tart > Programs > Fil e Explorer. The File Explore
window appears.
2. If the drive you want does not
already appear, tap on the
drop-down menu arrow to
select it, as shown here.
3. Navigate the fi le directory by
tapping on the folders and
fi les you want. If you want to
go up a level, tap on the Up
soft key at the bottom of the
screen.
4. Use the Menu soft key at
the bottom of the screen
to manipulate fi les.