Using the stylus – Juniper Systems Archer Reference Guide User Manual

Page 26

Chapter 3: Using the Hardware

If your device locks up, you can reset the device by pressing

the Power button for 10 seconds or until the screen goes

dark. After a few seconds, the device turns on again.

Restoring the device to its factory state. Follow the steps
below to restore the user storage, settings, and icons on your

Field PC to their original factory defaults.

WARNING! Restoring the Field PC to its original factory

state will permanently erase data saved on the Field PC, any

software you installed, and any changes you made to the

Field PC, including settings changes.

1. Reset the device from the power button menu or by

holding down the power button until the display goes

dark.

2. When the green notifi cation LED light appears on the

front of the Field PC, simultaneously press and hold the

following buttons for several seconds:

Clean Boot: Home, up arrow, Context

Clean Storage: Task, up arrow, Return

Clean Registry: Start, Context

Clean All: Return, left arrow, Context

3. Hold the buttons until the progress bar reaches the

second tick mark and then disappears. Factory settings

are restored automatically.

Using the stylus

The stylus is stored in an open slot at the top of the device. A

hole in the stylus end allows you to attach a lanyard.

Like the left button on a desktop computer mouse, the stylus

is a tool that lets you select or deselect items and enter data.

•

two plac
ress bar
drawn. E
o

boot.
o