Juniper Systems Archer Reference Guide - Manual (Page 33)

26
Installing a CF or SD card. To operate a card, insert the card
into the appropriate card slot, located under the standard
cap of the Field PC. (See the instructions in the previous
section for removing the standard cap.) The system should
automatically detect and use the card. However, if the card is
not recognized, try the following:
1. Install an appropriate driver by following the directions
on the device screen.
2. Operate the card by consulting the user’s guide that
came with the card.
Reinserting or changing a CF or SD card. Whenever you
remove or change a CF or SD card on the Field PC, wait at
least 6 seconds before inserting another card into the slot.
The Field PC needs this short time delay to properly identify
and use the newly inserted card. If a card is re-inserted
too quickly, the Field PC may need to reset. To avoid this
problem, close all programs
before changing or re-inserting
a card.
Copying data from a CF card,
SD card, or USB drive.
You
can run or copy data from a
peripheral device onto your
Field PC by following these
steps:
1. On the Field PC, tap Start >
Programs > File Explorer.
2. Tap and hold the fi le you
want to copy to your Field
PC. A pop-up menu appears, as shown here. Note: If you
want to copy multiple fi les, tap and drag the stylus over the
fi les. Once the fi les are selected, tap and hold the stylus on the
fi les until a pop-up menu appears.