Juniper Systems Archer Reference Guide - Manual (Page 34)

Chapter 3: Using the Hardware
27
3. Select Copy.
4. Open the destination folder
where you want to place your
copied fi le.
5. Tap and hold the stylus on
the white space below the
existing fi les until the pop-up
menu appears again.
6. Select Paste. The fi le is copied
and its name appears on the
screen.
Reattaching the standard cap. To
reattach the standard cap, follow
these steps:
1. Make sure the hand strap is attached to its top latch.
2. Place the standard cap over the case.
3. Use a screwdriver to turn the standard cap screws
until they are fi rmly in place.
CAUTION: Do not overtighten the screws. Tightening
the screws over 12-in-lb (1.36 N-m) could result in a failure.
The torque specs for the standard cap are
2-in-lb (0.23 N-m).
CAUTION: When the standard cap is removed, the Field PC is
not sealed. Avoid exposing the Field PC to moisture when the
standard cap is removed, and tighten the standard cap screws
fi rmly after you replace the standard cap. Failure to replace the
standard cap properly may void your warranty.
!
!