FingerTec Ingress User Manual
Page 38
38
To create users manually
You must manually create users in Ingress if only the Ingressus controller is installed in the
environment because you cannot enroll users fingerprint, password or card ID directly to
Ingressus. Therefore, enroll them in Ingress by scanning fingerprint with OFIS-Y scanner (fin-
gerprint), or insert password or card number of each user in Ingress.
You can create users by batch by assigning a running user ID for each user. In case you are
assigning RFID cards to every user, where the card numbers are in sequence, you can create
users by batch too.
To add users one-by-one:
1. Click
New User
.
2. Fill in the user biodata.
3. Click
Add and continue
to
continue to add next user.
4. Refer to
4.3.1
to learn how to
enroll fingerprint by using
OFIS-Y scanner.
To add users by batch:
1. Define the start and end
User
ID
.
2. Provide the starting Card Num.
if users are using card in run-
ning sequence number.
3. Define a general
Username
to attach with the user ID, for
example Staff1234. You can
amend the username accord-
ingly afterwards.
4. Provide the
Designation
if all
users share the same post. Ig-
nore this if they have different
designations.
5. Press
Execute
to start to generate users.