FingerTec Face ID 2 Installation Guide - Manual

Back Plate
4 feet / 1.2 meter
(recommended)
TCP/IP PORT
POWER
ADAPTER
PORT (A)
RS232/RS485 SERIAL PORT
USB PORT
ACCESS
CONTROL
PORT
ALARM PORT
Wiegand OUT
RS232
RS232
cable
RS485
485-
485+
GND
TXD
RXD
GND
WD1
WD2
3rd party controller
with 26 bits wiegand
input
RX+
RX-
1. RS485 Single Connection
RS232/RS485
Data Converter
RX+
RX-
RS232/RS485
Data
Converter
2. RS485 Network Connection
485+
485-
485+
485-
485+
4851
GND
+12V DC12V 3A
Power Supply
POWER SUPPLY (B)
Door Lock connector. Refer to Appendix I
Step 1
Determine the Location and Positioning
of the Installation
•
Avoid installing the terminals in locations that has contact with
a strong light source (e.g direct sunlight, spotlight, fluorescent
light, etc)
•
Avoid installing the terminals in locations with high moisture or
condensation levels in the air
•
The recommended installation height of the terminal from the
ground is 1.2 meter.
Step 2
Mounting of Terminals on A Wall
•
After determining the height of the terminal from the ground
level and have made the relevant marks on the wall, drill the
screws into the wall to hang the back plate.
Refer to Appendix II for dimensions and measurements of instal-
lation.
Installation Guide
w w w . f i n g e r t e c . c o m
Face ID2
Face & Fingerprint Recognition for
Time Attendane & Door Access Control System
INSTALLATION TIPS:
Best installation location of Face ID 2
must
1 - Avoid sunlight.
2 - 2 meters away from any light source i.e.
ceiling direct flourescent light
3 - Suggested 1.2m from the ground level
(measure from ground to the face captur-
ing camera)
Step 3
Wiring for Power Supply
1. Use the power adapter provided in the package and insert the
power adapter to the port marked A in the diagram.
2. Use power cables (black and red) to connect to a linear power
supply with specifications of 5VDC 3A (Marked B).