AERCO ProtoNode Gateway Rev 1 (with internal LEDs) User Manual
User manual, Aerco/protonode gateway
Table of contents
Document Outline
- 2.1 Installation Steps For The Customer
- 2.2 Record Identification Data
- 2.3 Configure the DIP Switches
- 3.1 ProtoNode RER and LER showing connection ports
- 3.2 ACS/BMS II/BMS Wiring Connections to ProtoNode RER and LER
- 3.3 Modulex BCM
- 3.4 ECS
- 3.5 C-MORE
- 4.1 Wiring the ProtoNode RER to RS-485 Field Protocol
- 4.2 Wiring the ProtoNode LER Field Port to a LonWorks network
- 4.3 Power-Up the ProtoNode RER or LER
- 4.4 Commissioning the ProtoNode LER on a Lonworks network
- 4.5 Sending Write Values
- 5.1 Connect the PC to the ProtoNode via the Ethernet port
- 5.2 Connect to the ProtoNode using RUI (Ruinet)
- 5.3 Set IP Address for BACnet/IP