Leica Geosystems TPS1100 Professional Series - User Manual - Manual (Page 78)

78 System functions TPS1100 - User Manual 2.2.1en
This function is for switching between
the display masks. If no mask is
defined, or only one, this function key
does not appear.
Switching between display masks (>DISP) Offset
The Offset function allows offset
points to be determined, for instance
when the reflector cannot be set up
directly on a point. Transverse, longi-
tudinal and/or elevation offsets can
be defined from the reflector position
to the offset point.
All of the displayed and recorded
measurement data are calculated in
relation to the offset point.
The values for target eccentricity will
be retained after storage with the
choice of "Permanent" in the Offset
Mode. The values will be set to zero
with the choice of "No reset after
REC".
1100QS07
O
ffs.Lngth -
Offs.Cross -
O
ffs.Lngth +
Offs.Cross +
Offset PT.
Elev. +:
Offset point is
higher than
measurement