Leica Geosystems TPS1100 Professional Series - User Manual - Manual (Page 49)

49
TPS1100 - User Manual 2.2.1en System functions
6
10
12
21
26
System functions
This section describes the system
functions of the TPS1100
instruments.
The presentation of the dialogs, and
the sequence and names of the
individual functions, are in
accordance with the basic TPS1100
configuration.
Data configuration
Data job (D JOB) and meas. job (M JOB)
A distinction is made between:
• Input data, which are generally
fixed-point coordinates, and
• Output data, which are generally
measurements, coordinates, or
values derived from "new points."
It is useful to store the input data and
the output data in two separate files,
although they can be stored together
in one file.
Up to 60 files can be managed.
The names of the files can be
chosen freely, but the extension must
always be GSI (e.g.
"PROJ2563.GSI").
In the directory \LOG, additional data
from most of the loadable
applications can be stored in a
protocol file.
The data can be output in GSI format
to the serial interface instead of on to
the PC card.
If the data is stored on the
serial interface, no data from
the applications will be output to the
protocol file. Fixed-point coordinates
can be read only from the PC card.
The following dialog (e.g.
measurement file) can be basically
used to create, edit and delete files.
\Selection ( )
Meas Job
DEFAULT.GSI PC-Card
RS232 RS232
CONT NEW EDIT DEL α αα αα NUM
MC
|<<-- -->>| QUIT