Leica Geosystems TPS1100 Professional Series - User Manual - Manual (Page 102)

102 System parameters TPS1100 - User Manual 2.2.1en
6
0
2
21
26
45
After a distance
measurement, vertical angle,
slope distance, height difference, and
the elevation coordinate are
displayed as running values. Slope
distance, height difference, and the
elevation coordinate of the target
point are calculated from the initial
horizontal distance and currently
displayed vertical angle. The REC-
function records the displayed values
in the measurement file.
Hold after DIST This parameter
activates the vertical
angle mode "Hold after
DIST" for the following
measurements. In this
mode, the vertical angle
is fixed after a distance
measurement, whereas
the horizontal angle is
running.
Configuration parameters, continued
Sect. Beep
Hz sector beep
Sets the beep (ON/OFF) for angle
sectors.
Sect. Angle
Hz sector angle
Enters the angles for which a beep
should sound.
When the angle approaches 4°30' (5
gon), the beep becomes regular.
At 27' (0.5 gon) the beep is
continuous.
At 16" (0.005 gon) there is no beep.
The angle count always commences
at 0°00'00" (0.0000 gon).
Release V-angle
Running This parameter activates
the vertical angle mode
"Running" for the
following
measurements. In this
mode, the vertical angle
is continuously updated
with the telescope
movement.
Pay attention to the
following when using V-
angle setting "running" for the
determination of remote heights:
The active reflector height is applied
in the calculation of remote point
elevations. The reflector height must
be manually set to zero to display
and record the elevation of the
targeted remote point.