Leica Geosystems TPS1100 Professional Series - User Manual - Manual (Page 32)

32
TPS1100 - User Manual 2.2.1en Checking and adjusting
6
0
2
21
Initiate the measurement of
the longitudinal and
transverse tilt ( l, t ).
Compensator (electronic bubble)
The determination of the index error
for the longitudinal and transverse
axes of the compensator ( l, t )
corresponds to the determination of
the centre of the bubble used in the
level.
The instrument should be
set up away from warmth
coming from one side some
time before the calibration
so that it can adjust to the ambient
temperature.The index error for the
longitudinal and transverse axes is
determined at the factory and adjusted
to zero before delivery.
Activate the calibration
procedure. (Refer to display
on page 30)
The longitudinal and transverse axes
(l, t) are displayed afterwards in the
following dialog.
Vertical axis
If the tilt cannot be measured, e.g.
due to an unstable instrument, the
error message ERROR: 557 is
displayed and the following keys are
defined:
Repeat measurement.
Abort measurement.
Non-motorized instruments perform
the second measurement after the
alidade of the instrument has been
turned 180° (200 gon), with an
accuracy of ±4° 30' (±5 gon).
After the initial measurement has
been started by pressing the key
, motorized instruments will
automatically complete the
determination of l and t without any
other assistance.
The following dialog is displayed after
completing the first tilt measurement
with non-motorized instruments.
Main\ Compens.Index Error
1st tilt measurement in any
face
L Compens.: 0°00'25"
T Compens.: 0°00'04"
MEAS
MC
QUIT
q
l
1100Z01