CANOGA PERKINS 9145E NID Software Version 4.10 - Manual (Page 53)

Diagnostics 9145E NID Software User’s Manual
Loopback Setup
41
Chapter 4
Diagnostics
4.0 Diagnostic Functions
From the Main Menu (Figure 2-3), select (2) Diagnostics. The Diagnostics screen (Figure 4-1)
opens. Diagnostics options set up loopback, VLAN loopback, latency and jitter testing, cable
diagnostics, and PING tests.
Figure 4-1 Diagnostics screen
4.1 Loopback Setup
The Loopback Setup screen is used to configure and initiate loopback diagnostics. Packets are
looped back at the User or Network port based on the Loop Test MAC address of the 9145E; all
packets not addressed to the Loop Test MAC Address are dropped. The 9145E can be
configured to swap origination and destination MAC addresses of the test packets and to
Canoga Perkins Corp. Ethernet Network Interface Device 29-JAN-2009
9145E-101-2-0 V04.10 05:15:01
---------------------------------- DIAGNOSTICS --------------------------------
1) Loopback Setup
2) Latency/Jitter Test
3) PING Generation
4) VLAN Loopback
5) Cable Diagnostics
6) Network Performance
7) Throughput Test
8) SOAM Based Diagnostics
9) Service Activation
Select [1-9]:
------------------------------------Messages-----------------------------------