CANOGA PERKINS 9145E NID Software Version 4.10 - Manual (Page 158)

9145E NID Software User’s Manual Port Information
Port Configuration
146
5.2.4.5 L2CP Port Filters
To enable or disable port filters, on the Port Filters screen (Figure 5-14), type 4 and press Enter.
The L2CP Port Filters screen (Figure 5-15) opens.
Type the number of the filter you wish to modify and press Enter. Press the Space bar to enable
or disable the filter. Press Esc to return to the previous screen.
Figure 5-15 L2CP Port Filters screen
NOTE: These filters are for both User and Network ports. You cannot set a filter for only one type
of port.
1. STP MSTP RSTP BPDU Filter These protocols may co-exist on a carrier network. When
this attribute is enabled, the 9145E filters packets related to any of these protocols:
• STP (Spanning Tree Protocol)
• MSTP (Multiple Spanning Tree Protocol)
• RSTP (Rapid Spanning Tree Protocol)
• BPDU (Bridge protocol data units)
Canoga Perkins Corp. Ethernet Network Interface Device 03-JAN-1970
9145E-761-0-0 V04.10 05:22:01
------------------------------L2CP PORT FILTERS---------------------------------
1) STP MSTP RSTP BPDU Filter Disabled
2) Pause Filter Disabled
3) LACP Filter Disabled
4) Port Authentication Filter Disabled
5) E-LMI Filter Disabled
6) Provider Bridge Filter Enabled
7) LLDP Filter Enabled
8) MVRP Filter Enabled
9) MMRP Filter Enabled
10) CDP Filter Enabled
11) VTP Filter Enabled
12) PagP Filter Enabled
13) PVST+ BPDU Filter Disabled
14) Link OAM PDU Filter Disabled
15) UDLD Filter Disabled
16) EDP (Extreme Discovery) Disabled
Select [1-16, (P)revious filters]:
------------------------------------Messages-------------------------------------