BendixKing KSN 770 - Pilots Guide - Manual (Page 90)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014
KSN 770 Radio
5-8
Honeywell International Inc. Do not copy without express permission of Honeywell.
The radio tuning pop--up window is removed by pushing OK on the
touchscreen, pushing the BACK bezel softkey, touching outside the
pop--up window display area, or pushing the radio control knob.
Stored Frequency List
To view or edit a stored COM frequency, push the on--screen standby
COM frequency field in the lower--left corner of the display, then push
the CH bezel softkey. The stored frequency list, shown in Figure 5--10,
is then displayed.
Figure 5--10
Stored Frequencies
A stored frequency can be selected from the stored frequency list by
pushing in the joystick knob (as indicated by PSH TO SELECTS in
the lower--right corner of the display) or by touching the selected
frequency on the touchscreen. When this selection is made, the
frequency is placed into the standby frequency field. The stored
frequency window does not close when a stored frequency is entered.
Pushing the BACK bezel softkey or touching the touchscreen outside
the pop--up window display area closes the window.
The stored frequency list supports the selection of the stored
communication frequencies in the range of 118.000 MHz to
136.990 MHz when 8.33 kHz VHF channel spacing is selected (by the
menu) and 118.000 MHZ to 136.975 MHz when 25 kHz VHF channel
spacing is selected.
NOTE: The stored frequency lists for 8.33 kHz and 25 kHz channel
spacing are independent of each other. Changing the channel
spacing on the menu displays a different stored frequency
list.