Table 12-1 lightning annunciators, Error annunciators – BendixKing KSN 770 - Pilots Guide User Manual
Page 254

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014
12-5
Lightning Detection View
Honeywell International Inc. Do not copy without express permission of Honeywell.
Error Annunciators
Lightning symbols are removed from display
and a red horizontal line is displayed through the
strike or cell mode rate annunciator when any of
the following conditions occur:
D
The Stormscope
receiver reports a fault or error
D
The heading is invalid or unavailable
D
Lightning data is not detected
D
Position invalid (only removed from NAV MAP view).
Table 12--1 lists the possible annunciators and conditions that are
displayed in the middle of the STRIKES view when one of the conditions
are met.
Table 12--1
Lightning Annunciators
Annunciator
Condition
TEST INIT
Displayed when sensor is in
self--test mode.
TEST INIT FAIL
Displayed when a self--test report
is not received within 10 seconds.
FAIL
The sensor status is an undefined
or fatal fault.
ERROR
The sensor status is an undefined
recoverable error.
ERROR ANT ERR
The sensor status is a recoverable
antenna error.
ERROR MIC INHIBIT STUCK The sensor status is a recoverable
inhibit line stuck error.
ERROR ANT JMP CHG
The sensor status is a recoverable
antenna jumper changed error.
FAIL HDG INVALID
Heading is invalid, not available,
or not configured.
FAIL NO LINK
When configured and data is not
detected.