BendixKing KSN 770 - Pilots Guide - Manual (Page 77)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014 4-5
Menu
Honeywell International Inc. Do not copy without express permission of Honeywell.
Brightness control is available on the
left--side of each page of the menu.
Brightness control has two modes;
manual ( MANUAL BRT ) and
automatic ( AUTO BRT ). Toggling
between the manual and automatic
modes is accomplished by pushing the
bezel softkey adjacent to
MANUAL BRT or AUTO BRT . In
manual mode, brightness can be
controlled in two ways; Pushing the
zoom- in/+ or zoom- out/- bezel keys
or pushing the brightness level key
( BRT: 90 for example) and rotating the
joystick knob to change the level. When
the joystick knob can be rotated to
change the brightness level, BRT is displayed in magenta. Manual
mode has a range of 1 to 100. In automatic mode, backlight intensity
is automatically adjusted based on the sensed ambient light conditions
detected by the integral photocell. The power--up default is
AUTO BRT .
Brightness control is always displayed while the menu is displayed to
permit the pilot to quickly adjust the screen brightness. Also, in the
event the screen becomes too dark for the pilot to view the menu, the
pilot can always push the zoom--in/+ bezel key to increase the screen
brightness. If not in Menu, push the FMS bezel key then push the
MENU bezel key and then hold the zoom--in/+ bezel key to increase
screen brightness.
NOTE: MANUAL BRT can also be selected by pushing the
adjacent bezel softkey next to the brightness value when
AUTO BRT is active.
Table 4--1 lists the functions available for selection in the menu.
Table 4--1
Menu Control States
Feature Available Options/Range
Page 1/6
Orientation Indicator ON
OFF