Figure 12-3 strike mode rate annunciator, Figure 12-4 cell mode rate annunciator, Strikes sensor status – BendixKing KSN 770 - Pilots Guide User Manual
Page 253

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014
Lightning Detection View
12-4
Honeywell International Inc. Do not copy without express permission of Honeywell.
Strike mode symbols are displayed as an amber
x
and cell mode
symbols are displayed as an amber
+
. Both symbols are removed
from the display after 3 minutes, and recent strikes overlay older
strikes.
Strikes Sensor Status
When the Stormscope
is not in self--test mode, the rate annunciator
(
+
RATE #
or
x
RATE #
), located in the lower--right corner of the
view, displays the mode symbol and current strike rate. Figure 12--3
shows the strike mode rate annunciation. Figure 12--4 shows the cell
mode rate annunciation.
NOTE: Pushing the
CLR
bezel softkey
in 3R resets the rate to 0.
Figure 12--3
Strike Mode Rate Annunciator
Figure 12--4
Cell Mode Rate Annunciator
When the Stormscope
is in self--test mode,
STKS TEST
is displayed
in place of the rate annunciation.
Lightning symbols are removed and
xRMVD
or
+RMVD
replaces the rate annunciator in the
lower--right corner when the range is less than
20 NM. Lightning data is not displayed if aircraft heading information is
not available.