BendixKing KSN 770 - Pilots Guide - Manual (Page 435)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014
Flight Management System (FMS)
15-162
Honeywell International Inc. Do not copy without express permission of Honeywell.
Present position is selectable when the current GPS position is valid.
When the mode is PPOS , the present position latitude and longitude
are displayed in cyan in 1L, which uses the present aircraft position as
the origin waypoint. When the current GPS position is not valid, last
know GPS position is selectable. When the mode is LAST POS , the
last valid GPS position is displayed in 1L and used for calculations.
The power--up default is WPT.
Efficiency -- The FMS calculated fuel efficiency is displayed in this field
with a resolution of 0.1 NM per gallon.
Fuel at -- The FMS calculated amount of fuel at the destination waypoint
is displayed in this field with a resolution of 0.1 gallon.
Range -- The FMS calculated range is displayed in this field with a
resolution of 0.1 NM.
RSRV at -- The FMS calculated reserves of fuel remaining at the
destination is displayed in this field in HH:MM:SS format.
Endurance -- The FMS calculated endurance is displayed in this field
in HH:MM:SS format.
Fuel Flow -- The fuel flow is entered in this field with a resolution of
0.1 gallon per hour. The power--up default is 0.0
GAL/HR
.
Fuel on Board -- The amount of fuel--on--board is entered in this field.
The power--up default is 0.0
GAL
. The amount of fuel on board is
entered with a resolution of 0.1 gallon. When fuel is added to the aircraft,
the pilot must manually update the fuel quantity.
Destination -- The Destination touchscreen softkey is displayed
when the mode in 4L is either WPT or PPOS. The pilot can manually
define the destination waypoint in this mode. The STORED/ACTIVE
touchscreen softkey toggles the destination from the stored flight plan
or the active flight plan destination. When ACTIVE is selected, the
Flight Plan touchscreen softkey in 1L becomes grayed out and
displays ACTIVE . The power--up default is green dashes ( ---------- ).
Ground Speed -- The groundspeed is entered in this field in knots. The
power--up default is 00
KT
.
Back -- Pushing the BACK bezel softkey displays the UTILITY page.