BendixKing KSN 770 - Pilots Guide - Manual (Page 434)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014 15-161
Flight Management System (FMS)
Honeywell International Inc. Do not copy without express permission of Honeywell.
Origin Wpt/Flight Plan/Latitude and Longitude -- The touchscreen
softkey displayed in this field changes depending on the selected mode
in 2L. When the Origin Wpt touchscreen softkey is displayed, the
origin waypoint can be manually entered by the pilot using the
QWERTY keypad. When the Flight Plan touchscreen softkey is
displayed, the pilot can select from a list of stored flight plans to use for
origin and destination waypoints. When the latitude and longitude is
displayed, the present position (or last valid position) is used as the
origin waypoint. The power--up default is green dashes ( ------------ ).
Mode -- Possible modes are WPT , FLT PLAN , and PPOS (or
LAST POS ). When the mode is WPT , the Origin Wpt
touchscreen softkey is displayed in 1L, which permits the pilot to define
the origin and destination waypoint using the QWERTY keypad.
When the mode is FLT PLAN , the Flight Plan touchscreen softkey
is displayed in 1L, which permits the pilot to choose from stored flight
plans to use for origin and destination calculations. In addition,
Flight Leg is displayed in the center of the page and to the right of the
Flight Plan touchscreen softkey, as shown in Figure 15--149. The
flight leg function permits the pilot to view fuel calculations on a
leg--by--leg basis. The flight legs are changed by using the interactive
touchscreen to push the PREV or NEXT touchscreen softkey or by
rotating the joystick knob as indicated by FLT LEG , displayed in the
lower--right corner.
Figure 15--149
Flight Leg