Pilz PNOZ s50 C - Manual (Page 50)

Operation
Operating Manual PNOZ s50
1002194­EN­02 50
Cat. No. Error message Description Remedy
0 2 Enter Stop System is in "STOP" state Purely for information
0 3 Enter Run System is in "RUN" state Purely for information
1 0 ACK IO­Fault The "IO­Fault" error has been re­
set with the inputs Y10/Y11 and/
or Y20/Y21 (1/0 pulse edge) Purely for information
4 0 Copy Config The configuration has been
loaded from the chip card to the
device. Purely for information
4 1 Copy Config The device has saved the config­
uration to the chip card. Purely for information
4 2 Missing Card There is no chip card in the card
slot. Insert a valid chip card into the
card slot
4 3 Invalid Card The data on the chip card is in­
valid ­ Check chip card
­ Insert a valid chip card into the
card slot
4 4 Mems. Differ The data on the chip card differs
from the data in the device ­ Use a chip card containing the
device configuration
­ Write the device configuration to
chip card
4 5 Card Removed The chip card has been removed
during operation Insert a valid chip card into the
card slot
4 6 Unknown Card The chip card does not contain
device data for the PNOZ s50 Insert a valid chip card into the
card slot
5 0 Wrong Pin The password is invalid Enter a valid password
5 1 Pin Changed The password has been
changed Purely for information
5 2 Count. at Max The event counter has reached
the maximum value 99999999.
The event counter is not reset
automatically. Reset event counter
5 3 Chan. Differ Error in the device's parameter
settings Check parameter settings
6 0 Supply NOK Supply voltage B1/B2 to the
power circuits is outside the per­
mitted range.
Parameter 1:
0x000000002
Check the supply voltage
6 1 Supply OK Supply voltage B1/B2 to the
power circuits is once again
within the permitted range.
Parameter 1:
0x000000002
Purely for information
7 0 Reset Config The device has been reset to its
default settings. Purely for information