ETS-Lindgren FM5004 Field Monitor (Archived) - Manual (Page 52)

SYSTEM ALARM
Contains the items
associated with
setting up the alarm
for probe failures or
system errors.
• Momentary Probe Fail: The alarm will activate when a momentary error
occurs in a probe or if an error occurs during
communication with a probe.
• Hard Probe Fail: The alarm will activate when an error condition
occurs repeatably.
• Battery Enable: The alarm will activate when the voltage on an active
probe falls below the level at which normal probe
operation is guaranteed.
The battery alarm will become inactive when the
sample rate is set above 10 samples per second.
However, taking a battery measurement from either
the front panel or by a remote battery measurement
command will cause an alarm if the alarm is enabled
and the measurement causes an alarm condition.
52 | Menu System
Archived 10/19/10