ETS-Lindgren FM5004 Field Monitor (Archived) - Manual (Page 23)

4.0 Quick Start
Before placing into operation, follow the safety
information in the ETS-Lindgren
Product Information Bulletin included with your
shipment.
Before operating the FM5004, complete the steps in Before You Begin
on page 25.
Following are the basic steps to configure and operate the FM5004 Field Monitor.
To save time and improve accuracy during configuration, before you start the
following steps identify the modes and configurations you want for each channel
See Front Panel Controls and Indicators on page 25 for complete
information on using the switches, buttons, and other controls located
on the front of the FM5004.
1. Set the ARM/OFF switch on all probes to ARM.
2. Press on the FM5004.
3. Verify no error codes appear on the FM5004 display and that there are
no fault indications. If an error code appears or a fault is indicated, see
Troubleshooting and Error Handling on page 105.
4. Select the channel to which a probe is connected by pressing the
channel select switch for that channel, and then press Disp.
Select the desired axes and whether the data is for display or for
analog output.
5. If more than one probe is attached, repeat step 4 for each channel.
The configuration is saved in non-volatile memory. It will remain stored unless
altered, regardless of whether the FM5004 is powered on.
Quick Start | 23
Archived 10/19/10