Cisco 10000 User Manual
Page 72
2-12
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 2 Scalability and Performance
Configuring the Cisco 10000 Series Router for High Scalability
In
, the output of the test virtual-template <number> subinterface command indicates
that the interface-specific command carrier-delay is set.
load-interval
Specifies the interval for load calculation for an
interface.
locaddr-priority
Assigns a priority group.
logging
Configures logging for an interface.
loopback
Configures the internal loopback on an interface.
mac-address
Manually sets the MAC address for an interface.
max-reserved-bandwidth
Specifies the maximum reservable bandwidth on
an interface.
mpoa
Multiprotocol over ATM (MPOA) interface
configuration commands.
multilink
Configures multilink parameters.
multilink-group
Puts the interface in a multilink bundle.
netbios
Defines Network Basic Input/Output System
(NetBIOS) access list or enables name-caching.
ntp
Configures the Network Time Protocol (NTP).
priority-group
Assigns a priority group to an interface.
qos pre-classify
Enables quality of service (QoS) preclassification.
random-detect
Enables weighted random early detection
(WRED) on an interface.
roles
Specifies roles (by entering roles mode).
sap-priority
Assigns a priority group.
sdlc
Configures Synchronous Data Link Control
(SDLC) to Logical Link Control type 2 (LLC2)
translation.
serial
Serial interface commands.
snmp
Modifies Simple Network Management Protocol
(SNMP) interface parameters.
source
Gets the configuration from another source.
stun
Serial Tunnel (STUN) interface subcommands.
transmit-interface
Assigns a transmit interface to a receive-only
interface.
trunk-group
Configures an interface to be in a trunk group.
tx-ring-limit
Limits the number of particles or packets that can
be used on a transmission ring on an interface.
Table 2-7
Interface-Specific Commands That Prevent PPP Scaling (continued)
Command
Function