New features in cisco ios release 12.2(31)sb3, New features in cisco ios release 12.2(31)sb2 – Cisco 10000 User Manual
Page 50
1-18
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 1 Broadband Aggregation and Leased-Line Overview
New Features, Enhancements, and Changes
New Features in Cisco IOS Release 12.2(31)SB3
In Cisco IOS Release 12.2(31)SB3, support was added on the Cisco 10000 series router for the following
features and functionality:
•
IS-IS-MIB
For more information, see the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122limit/122sg25/
ismibspt.htm
•
QoS: MQC Classification, Policing, and Marking on LAC
Note
Support for this feature on the PRE3 was introduced in Cisco IOS Release 12.2(31)SB2.
For detailed information about this feature, see the “Shaping Traffic” chapter in the
Cisco 10000 Series Router Quality of Service Configuration Guide, located at the following URL:
•
TCP MSS Adjust
For more information, see the “Configuring PPPoE over Ethernet and IEEE 802.1Q VLAN” chapter
in the Cisco 10000 Series Router Broadband Aggregation, Leased-Line, and MPLS Configuration
Guide, located at the following URL:
New Features in Cisco IOS Release 12.2(31)SB2
In Cisco IOS Release 12.2(31)SB2, support was added on the Cisco 10000 series router for the following
features and functionality:
•
ACL - Template ACL/12 Bit ACE
For more information, see the
“Configuring Template ACLs” section on page 22-1
•
Frame Relay - Multilink (MLFR-FRF.16)
For more information, see the following URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1838/products_feature_guide09186a0080134
a9e.html
•
Support was added for the PRE3. For more information, see the following URL:
f4a.html
•
IP Options Selective Drop
For more information, see the
“Protecting the Router from DoS Attacks” section on page 23-1
.