Configuring a virtual template interface, Configuring pppoe in a vpdn group – Cisco 10000 User Manual
Page 224
6-8
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 6 Configuring PPPoE over Ethernet and IEEE 802.1Q VLAN
PPPoE over IEEE 802.1Q VLANs
•
Configuring PPPoE in a VPDN Group, page 6-8
•
Configuring PPPoE in a BBA Group, page 6-9
The following sections describe how to perform these configuration tasks. For more information, see the
“Configuring Broadband Access: PPP and Routed Bridge Encapsulation” chapter in the Cisco IOS
Wide-Area Networking Configuration Guide.
Configuring a Virtual Template Interface
Configure a virtual template interface before you configure PPPoE on an IEEE 802.1Q VLAN interface.
The virtual template interface is a logical entity that is applied dynamically as needed to a serial
interface. To configure a virtual template interface, see the
“Configuring a Virtual Template Interface”
Creating an Ethernet 802.1Q Encapsulated Subinterface and Enabling PPPoE
To create an Ethernet 802.1Q encapsulated subinterface and enable PPPoE on it, enter the following
commands beginning in global configuration mode:
Configuring PPPoE in a VPDN Group
To configure a VPDN group for PPPoE and link it to the appropriate virtual template interface, enter the
following commands beginning in global configuration mode:
Command
Purpose
Step 1
Router(config)# interface GigabitEthernet
slot/module/port.subinterface-number
Creates a Gigabit Ethernet subinterface and enters subinterface
configuration mode.
Step 2
Router(config-subif)# encapsulation dot1q
vlan-id
Enables IEEE 802.1Q encapsulation on a specified subinterface
in VLANs.
Step 3
Router(config-subif)# pppoe enable
Enables PPPoE and allows PPPoE sessions to be created through
the specified subinterface.
Step 4
Router(config-subif)# pppoe max-sessions
number
Specifies the maximum number of PPPoE sessions that can be
terminated on this router from all interfaces.
Command
Purpose
Step 1
Router(config)# vpdn enable
Enables VPDN configuration on the router.
Step 2
Router(config)# vpdn-group name
Associates a VPDN group to a customer or VPDN profile.