Cisco 10000 - Manual (Page 29)

xxix
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
About This Guide
Document Organization
Chapter 9 Configuring the Multihop Feature Describes how to configure the multihop feature that enables
the Cisco 10000 series router to terminate sessions arriving in
L2TP tunnels from LACs and to forward the sessions through
new L2TP tunnels to the router’s peer L2TP Network Server
(LNS). Also describes how to configure the preservation of the
IP type of service (ToS) field for tunneled IP packets.
Chapter 10 Configuring Address Pools Describes address assignment mechanisms, including the
on-demand address pool manager feature and the overlapping
addresses feature. Describes how to configure each of these
features.
Chapter 11 Configuring Local AAA Server, User
Database—Domain to VRF Describes the Local AAA Server, User Database—Domain to
VRF feature, which extends the Cisco IOS AAA Authorization
to local AAA profiles on the router without using an AAA
Server.
Chapter 12 Configuring Traffic Filtering Describes the IP Receive ACLs and Time-Based ACLs features
that provide filtering capability for traffic that is destined for
the router and protects the router from remote intrusions.
Chapter 13 Unicast Reverse Path Forwarding Describes the Unicast Reverse Path Forwarding feature that
verifies if the path of an incoming packet is consistent with the
local packet forwarding information. The validity of this path
determines whether uRPF passes or drops the packet.
Chapter 14 Configuring Automatic Protection
Switching Describes the Multirouter Automatic Protection Switching
(MR-APS) feature that enables SONET connections to switch
from one SONET circuit to another SONET circuit if a circuit
failure occurs.
Chapter 15 Configuring IP Multicast Describes the IP Multicast feature.
Chapter 16 Configuring RADIUS Features Describes the RADIUS attribute screening, RADIUS transmit
retries, RADIUS Attribute 31: PPPoX Calling-Station-ID, and
RADIUS packet of disconnect features.
Chapter 17 Configuring L2 Virtual Private Networks Describes L2VPN features of both LS and AToM types
available on Cisco 10000 series router.
Chapter 18 Configuring L2VPN Interworking Describes L2 interworking features available on
Cisco 10000 series router.
Chapter 19 Configuring Multilink Point-to-Point
Connections Describes MLP and how to configure it on serial and ATM
connections on the Cisco 10000 series router.
Chapter 20 Configuring Gigabit EtherChannel
Features Describes Gigabit EtherChannel features available on
Cisco 10000 series router.
Chapter 21 Configuring IP Version 6 Lists the IPv6 features that are supported on the
Cisco 10000 series router and notes limitations of that support.
Chapter 22 Configuring Template ACLs Describes Template ACLs, in which one ACL represents many
similar ACLs.
Chapter 23 Protecting the Router from DoS Attacks Describes how to protect against denial of service (DoS)
attacks.
Chapter Title Description