Cisco 10000 User Manual
Page 449
19-31
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 19 Configuring Multilink Point-to-Point Protocol Connections
Configuring MLP Bundles and Member Links
Configuration Example for Adding ATM Links to an MLP Bundle
shows how to add ATM links to an MLP bundle. In the example, the virtual template
named Virtual-Template 1 is applied to PVCs 0/34, 0/35, and 0/36. Each of these PVCs is assigned to
MLP bundle group 1. Notice that all of the member links have the same encapsulation type. The router
does not support member links with different encapsulation types.
Example 19-3 Adding ATM Links to an MLP Bundle
Router(config)# interface Multilink 1
Router(config-if)# ip address 10.6.6.1 255.255.255.0
Router(config-if)# ppp multilink
Router(config-if)# ppp multilink group 1
!
Router(config)# interface virtual-template1
Router(config-if)# ppp max-configure 110
Router(config-if)# ppp max-failure 100
Router(config-if)# ppp timeout retry 5
Router(config-if)# keepalive 30
Router(config-if)# no ip address
Router(config-if)# ppp multilink
!
Router(config)# interface atm 6/0/0
Router(config-if)# no ip address
Router(config-if)# hold-queue 4096 in
!
Router(config)# interface atm 6/0/0.1 point-to-point
Router(config-if)# no ip address
Router(config-if)# pvc 0/34
Router(config-if-atm-vc)# vbr-nrt 512 256 20
Router(config-if-atm-vc)# encapsulation aal5snap
Router(config-if-atm-vc)# protocol ppp Virtual-Template 1
Router(config-if-atm-vc)# ppp multilink group 1
Step 9
Router(config-if-atm-vc)# protocol ppp
virtual-template
number
Enables PPP sessions to be established over the ATM PVC
using the configuration from the virtual template you specify.
Use this command only if you specified aal5snap as the
encapsulation type and you are configuring MLP on multiple
VCs.
number is a nonzero number that identifies the virtual
template that you want to apply to this ATM PVC.
Step 10
Router(config-if-atm-vc)# ppp multilink group
group-number
Associates the PVC with an MLP bundle.
group-number is a nonzero number that identifies the
multilink group. Valid values are:
•
Single-VC MLP over ATM—10,000 and higher.
•
Multi-VC MLP over ATM—1 to 9999
(Release 12.2(28)SB and later) or from 1 to 9999 and
65,536 to 2,147,483,647 (Release 12.2(31)SB2 and
later).
The group-number must be identical to the specified
multilink-bundle-number of the MLP bundle to which you
want to add this link.
Command
Purpose