Cisco 10000 - Manual (Page 116)

3-34
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Chapter 3 Configuring Remote Access to MPLS VPN
Configuration Examples for RA to MPLS VPN
PPPoE to MPLS VPN Configuration Example
Example 3-13 shows how to configure the RA to MPLS VPN feature with one VRF for PPPoE sessions.
Example 3-13 Configuring PPPoE to MPLS VPN
!
!Enables the AAA access control model.
aaa new-model
!
!Configures AAA accounting.
aaa authentication login default none
aaa authentication enable default none
aaa authentication ppp default group radius
aaa authorization config-commands
aaa authorization network default local
aaa session-id common
enable password cisco
!
username pppoe password 0 pppoe
username pppoa password 0 pppoa
username common password 0 common
!
!Preprovisions slots in the Cisco 10000 series router for line cards.
card 1/0 1gigethernet-1
card 2/0 1gigethernet-1
card 3/0 1oc12pos-1
card 4/0 1oc12pos-1
card 5/0 1oc12atm-1
card 6/0 1oc12atm-1
card 7/0 4oc3atm-1
card 8/0 4oc3atm-1
!
!Creates the common VRF.
ip vrf common
rd 100:1000
route-target export 100:1000
route-target import 100:1000
!
!Specifies the VPDN group to be used to establish PPPoE sessions and specifies the maximum
!number of PPPoE sessions to be established over a virtual circuit.
vpdn-group pppoe
accept-dialin
protocol pppoe
virtual-template 1
pppoe limit per-mac 32000
pppoe limit per-vc 1
!
no virtual-template snmp
!
!Configures the small buffer.
buffers small permanent 15000
!
vc-class atm vpn
protocol pppoe
encapsulation aal5snap
!
!Defines the general loopback interface used for reachability to the router and as a
!source IP address for sessions (IBGP, TDP, and so on).
interface Loopback0
ip address 10.16.3.1 255.255.255.255
ip ospf network point-to-point