Dell PowerEdge M805 User Manual
Page 81
Command Groups
43
default-metric
Sets a default for the metric of distributed routes.
ROSV3
distance ospf
Sets the route preference value of OSPF in the router.
ROSV3
enable
Resets the default administrative mode of OSPF in the
router (active).
ROSV3
exit-overflow-interval
Configures the exit overflow interval for OSPF.
ROSV3
external-lsdb-limit
Configures the external LSDB limit for OSPF.
ROSV3
ipv6 ospf
Enables OSPF on a router interface or loopback interface.
IC
ipv6 ospf areaid
Sets the OSPF area to which the specified router interface
belongs.
IC
ipv6 ospf cost
Configures the cost on an OSPF interface.
IC
ipv6 ospf dead-interval
Sets the OSPF dead interval for the specified interface.
IC
ipv6 ospf hello-interval
Sets the OSPF hello interval for the specified interface.
IC
ipv6 ospf mtu-ignore
Disables OSPF maximum transmission unit (MTU)
mismatch detection.
IC
ipv6 ospf network
Changes the default OSPF network type for the interface.
IC
ipv6 ospf priority
Sets the OSPF priority for the specified router interface.
IC
ipv6 ospf retransmit-interval
Sets the OSPF retransmit interval for the specified
interface.
IC
ipv6 ospf transmit-delay
Sets the OSPF Transmit Delay for the specified interface.
IC
ipv6 router ospf
Enters Router OSPFv3 Configuration mode.
GC
maximum-paths
Sets the number of paths that OSPF can report for a given
destination.
ROSV3
redistribute
Configures the OSPFv3 protocol to allow redistribution of
routes from the specified source protocol/routers.
ROSV3
router-id
Sets a 4-digit dotted-decimal number uniquely identifying
the Router OSPF ID.
ROSV3
show ipv6 ospf
Displays information relevant to the OSPF router.
PE
show ipv6 ospf abr
Displays the internal OSPFv3 routes to reach Area Border
Routers (ABR).
PE
UE
show ipv6 ospf area
Displays information about the area.
PE
show ipv6 ospf asbr
Displays the internal OSPFv3 routes to reach Autonomous
System Boundary Routes (ASBR).
PE
UE
show ipv6 ospf database
Displays information about the link state database when
OSPFv3 is enabled.
PE
Command
Description
Mode*