Dell PowerEdge M805 - Manual (Page 173)

Denial of Service Commands 141
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example activates L4 Port Denial of Service protection.
console(config)#dos-control l4port
dos-control sipdip
Use the dos-control sipdip command in Global Configuration mode to enable Source IP Address
= Destination IP Address (SIP=DIP) Denial of Service protection. If the mode is enabled, Denial
of Service prevention is active for this type of attack. If packets ingress with SIP=DIP, the packets is
dropped if the mode is enabled.
Syntax
dos-control sipdip
no dos-control sipdip
Default Configuration
Denial of Service is disabled.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example activates SIP=DIP Denial of Service protection.
console(config)#dos-control sipdip
dos-control tcpflag
Use the dos-control tcpflag command in Global Configuration mode to enable TCP Flag Denial of
Service protections. If the mode is enabled, Denial of Service prevention is active for this type of
attack. If packets ingress having TCP Flag SYN set and a source port less than 1024, having TCP