Dell PowerEdge M805 - Manual (Page 772)

780 PIM-SM Commands
www
.dell.com | support.dell.com
• candidate — Display PIM-SM candidate-RP table information.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays PIM information for candidate Rendezvous Points (RPs) for
all IP multicast groups.
console#show ip pimsm rp all
RP SET TABLE
Group Address Group Mask Address Hold Time Expiry Time Component
(hh:mm:ss)(hh:mm:ss)
------------- ---------- ------- --------- ----------- --------
show ip pimsm rphash
Use the show ip pimsm rphash command in Privileged EXEC mode to display the RP router being
selected from the set of active RP routers. The RP router for the group is selected by using a hash
algorithm.
Syntax
show ip pimsm rphash groupaddr
• groupaddr—Valid group IP address.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.