Dell PowerEdge M805 - Manual (Page 734)

740 OSPFv3 Commands
www
.dell.com | support.dell.com
ipv6 ospf transmit-delay
Use the ipv6 ospf transmit-delay command in Interface Configuration mode to set the OSPF
Transmit Delay for the specified interface.
Syntax
ipv6 ospf transmit-delay seconds
no ipv6 ospf transmit-delay
• seconds—OSPF transmit delay for the specified interface. In addition, it sets the
estimated number of seconds it takes to transmit a link state update packet over this
interface. (Range: 1 to 3600 seconds)
Default Configuration
No default value.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF Transmit Delay at 100 seconds for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf transmit-delay 100
ipv6 router ospf
Use the ipv6 router ospf command in Global Configuration mode to enter Router OSPFv3
Configuration mode.
Syntax
ipv6 router ospf
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode