Dell PowerEdge M805 - Manual (Page 67)

Command Groups 29
name Configures a name to a VLAN. IC
protocol group Attaches a vlanid to the protocol-based VLAN identified by
groupid. VLAN
protocol vlan group Adds the physical unit/port interface to the protocol-based
VLAN identified by groupid. IC
protocol vlan group all Adds all physical unit/port interfaces to the protocol-based
VLAN identified by groupid. GC
show dvlan-tunnel Displays all interfaces enabled for Double VLAN
Tunneling. PE
show dvlan-tunnel interface Displays detailed information about Double VLAN
Tunneling for the specified interface. PE
show interfaces switchport Displays switchport configuration. PE
show port protocol Displays the Protocol-Based VLAN information for either
the entire system or for the indicated group PE
show switchport protected Displays protected group/port information. PE
show vlan Displays VLAN information. PE
show vlan association mac Displays the VLAN associated with a specific configured
MAC address. PE
show vlan association subnet Displays the VLAN associated with a specific configured IP
subnet. PE
switchport access vlan Configures the VLAN ID when the interface is in access
mode. IC
switchport forbidden vlan Forbids adding specific VLANs to a port. IC
switchport general acceptable-
frame-type tagged-only Discards untagged frames at ingress. IC
switchport general allowed vlan Adds or removes VLANs from a port in General mode. IC
switchport general ingress-
filtering disable Disables port ingress filtering. IC
switchport general pvid Configures the PVID when the interface is in general
mode. IC
switchport mode Configures the VLAN membership mode of a port. IC
switchport protected Sets the port to Protected mode. IC
switchport protected name Configures a name for a protected group GC
switchport trunk allowed vlan Adds or removes VLANs from a port in general mode. IC
Command Description Mode*