Dell PowerEdge M805 - Manual (Page 271)

System Management Commands 249
ip address
Use the ip address command to set a static OOB port IP address.
Syntax
ip address addr mask gw
• addr—IP address to be set for the OOB port. (Range: Valid IP address)
• mask—Subnet mask. (Range: Valid mask)
• gw—Gateway IP address. (Range: Valid gateway IP address)
Command Mode
Interface Configuration (out-of-band)
Default Configuration
This command has no default configuration.
User Guidelines
No specific guidelines.
Example
console(config-if)#ip address 10.240.4.115 255.255.255.0
10.240.4.1
ip address none
Use the ip address none command to disable DHCP/BOOTP on the OOB port.
Syntax
ip address none
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (out-of-band)
User Guidelines
No specific guidelines.
Example
console(config)#interface out-of-band