Dell PowerEdge M805 - Manual (Page 718)

724 OSPFv3 Commands
www
.dell.com | support.dell.com
console(config-rtr)#area 1 nssa translator-stab-intv 100
area range
Use the area range command in Router OSPF Configuration mode to configure a summary prefix
for routes learned in a given area. There are two types of area ranges. An area range can be
configured to summarize intra-area routes. An ABR advertises the range rather than the specific
intra-area route as a type 3 summary LSA. Also, an area range can be configured at the edge of an
NSSA to summarize external routes reachable within the NSSA. The range is advertised as a type 5
external LSA. Use the no form of the command to remove the summary prefix configuration for
routes learned in the specified area.
Syntax
area areaid range ipv6-prefix/prefix-length {summarylink | nssaexternallink} [advertise | not-
advertise]
no area areaid range ipv6-prefix/prefix-length {summarylink | nssaexternallink}
• areaid—Valid OSPF area identifier.
• ipv6-prefix/prefix-length—Valid route prefix.
• summarylink—LSDB type
• nssaexternallink—LSDB type.
• advertise—Allows area range to be advertised.
• not-advertise—Suppresses area range from being advertised.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
The LSDB type must be specified by either summarylink or nssaexternallink, and the
advertising of the area range can be allowed or suppressed.
Example
The following example creates an area range for the area 1 NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 range 2020:1::1/64 summarylink