Dell PowerEdge M805 - Manual (Page 725)

OSPFv3 Commands 731
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets a default of 100 for the metric of distributed routes.
console(config)#ipv6 router ospf
console(config-rtr)#default-metric 100
distance ospf
Use the distance ospf command in Router OSPFv3 Configuration mode to set the route
preference value of OSPF in the router. Lower route preference values are preferred when
determining the best route. The type of OSPF can be intra, inter, type-1, or type-2. The OSPF
specification (RFC 2328) requires that preferences must be given to the routes learned via OSPF in
the following order: intra < inter < type-1 < type-2.
Syntax
distance ospf {intra | inter | type1 | type2} preference
no distance ospf {intra | inter | type1 | type2}
• preference—Route preference. (Range: 1-255)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets a route preference value of 100 for intra OSPF in the router.
console(config)#ipv6 router ospf
console(config-rtr)#distance ospf intra 100