Dell PowerEdge M805 - Manual (Page 730)

736 OSPFv3 Commands
www
.dell.com | support.dell.com
Syntax
ipv6 ospf dead-interval seconds
no ipv6 ospf dead-interval
• seconds—A valid positive integer, which represents the length of time in seconds that a
router's Hello packets have not been seen before its neighbor routers declare that the
router is down. The value for the length of time must be the same for all routers attached
to a common network. This value should be some multiple of the Hello Interval (i.e. 4).
(Range: 1-65535)
Default Configuration
40 seconds is the default value of seconds.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF dead interval at 100 seconds.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf dead-interval 100
ipv6 ospf hello-interval
Use the ipv6 ospf hello-interval command in Interface Configuration mode to set the OSPF hello
interval for the specified interface.
Syntax
ipv6 ospf hello-interval seconds
no ipv6 ospf hello-interval
seconds—A valid positive integer which represents the length of time of the OSPF hello
interval. The value must be the same for all routers attached to a network. (Range: 1-65535
seconds)
Default Configuration
10 seconds is the default value of seconds.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode