Dell PowerEdge M805 - Manual (Page 619)

IP Routing Commands 623
176.2.1.1 1
Routing Information Sources:
Gateway State
176.1.1.2 Full
External Preference: 60
Internal Preference: 20
show ip route
Use the show ip route command in Privileged EXEC mode to display the routing table.
Syntax
show ip route [protocol |address ip-address [subnet-mask | prefix-length] [longer-prefixes]]
• protocol—Specifies the protocol that installed the routes. (Range: connected, ospf, rip
static)
• ip-address—Specifies the network for which the route is to be displayed and displays the
best matching best-route for the address.
• subnet-mask—Subnet mask of the IP address.
• prefix-length—Length of prefix, in bits. Must be preceded with a forward slash (‘/’).
(Range: 0-32 bits)
• longer-prefixes—Indicates that the ip-address and subnet-mask pair becomes the prefix,
and the command displays the routes to the addresses that match that prefix.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the routing table.
console#show ip route
Route Codes: R - RIP Derived, O - OSPF Derived, C - Connected, S -
Static