Dell PowerEdge M805 - Manual (Page 709)

OSPF Commands 715
show ip ospf virtual-link brief
Use the show ip ospf virtual-link brief command in Privileged EXEC mode to display the OSPF
Virtual Interface information for all areas in the system.
Syntax
show ip ospf virtual-link brief
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF Virtual Interface information for all areas in the
system.
console#show ipv6 ospf virtual-link brief
Hello Dead Retransmit Transit
Area ID Neighbor Interval Interval Interval Delay
------- -------- -------- -------- ---------- --------
0.0.0.2 5.5.5.5 10 40 5 1
timers spf
Use the timers spf command in Router OSPF Configuration mode to configure the SPF delay and
hold time. Use the no form of the command to reset the numbers to the default value.
Syntax
timers spf delay-time hold-time
no timers spf
• delay-time—SPF delay time. (Range: 0-65535 seconds)
• hold-time—SPF hold time. (Range: 0-65535 seconds)
Default Configuration
5 is the delay-time default value. 10 is the hold-time default value.