Ethernet configuration commands – Dell PowerEdge M805 User Manual
Page 47
Command Groups
9
Ethernet Configuration Commands
Command
Description
Mode*
clear counters
Clears statistics on an interface.
PE
description
Adds a description to an interface.
IC
duplex
Configures the full/half duplex operation of a given
Ethernet interface when not using auto-negotiation.
IC
flowcontrol
Configures the flow control on a given interface.
GC
interface ethernet
Enters the interface configuration mode to configure an
Ethernet type interface.
GC
interface range ethernet
Enters the interface configuration mode to configure
multiple Ethernet type interfaces.
GC
mdix
Enables automatic crossover on a given interface.
IC
mtu
Enables jumbo frames on an interface by adjusting the
maximum size of a packet or maximum transmission
unit (MTU).
IC
negotiation
Enables auto-negotiation operation for the speed and
duplex parameters of a given interface.
IC
show interfaces advertise
Displays information about auto negotiation
advertisement.
PE
show interfaces configuration
Displays the configuration for all configured interfaces.
UE
show interfaces counters
Displays traffic seen by the physical interface.
UE
show interfaces description
Displays the description for all configured interfaces.
UE
show interfaces status
Displays the status for all configured interfaces.
UE
show statistics ethernet
Displays statistics for one port or for the entire switch.
PE
show storm-control
Displays the storm control configuration.
PE
shutdown
Disables interfaces.
IC
speed
Configures the speed of a given Ethernet interface when
not using auto-negotiation.
IC
storm-control broadcast
Enables Broadcast storm control.
IC
storm-control multicast
Enables the switch to count Multicast packets together
with Broadcast packets.
IC
storm-control unicast
Enables Unicast storm control.
IC
*NOTE:
For the meaning of each Mode abbreviation, see Mode Types on page 4.