Dell PowerEdge M805 - Manual (Page 665)

Multicast Commands 671
show ip mcast mroute static
Use the show ip mcast mroute static command in Privileged EXEC mode to display all the static
routes configured in the static mcast table if it is specified or display the static route associated
with the particular sourceipaddr.
Syntax
show ip mcast mroute static [sourceipaddr ]
• sourceipaddr—IP address of source.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the static routes configured in the static mcast table.
console#show ip mcast mroute static
STATIC ROUTES
Source IP Source Mask RPF Address Metric Interface
--------- --------------- ------------ ------ ---------
console#show ip mcast mroute static 10.1.1.1
Static Route with source IP address 10.1.1.1 does not exist.
show mrinfo
Use the show mrinfo command in Privileged EXEC mode to display the neighbor information of a
multicast-capable router from the results buffer pool of the router subsequent to the
execution/completion of a mrinfo command. The results that follow completion of the latest
mrinfo are available in the buffer pool after a maximum of two minutes beyond completion of the
show mrinfo command. A subsequent mrinfo command overwrites the contents of the buffer pool
with fresh results.