Igmp snooping querier commands, Ip igmp snooping querier, 14 igmp snooping querier commands – Dell PowerEdge M805 User Manual
Page 223
IGMP Snooping Querier Commands
195
IGMP Snooping Querier Commands
ip igmp snooping querier
This command enables/disables IGMP Snooping Querier on the system (Global Configuration
mode) or on a VLAN. Using this command, you can specify the IP address that the snooping
querier switch should use as source address when generating periodic queries. The no form of this
command disables IGMP Snooping Querier on the system. Use the optional address parameter to
reset the querier address to 0.0.0.0.
If a VLAN has IGMP Snooping Querier enabled, and IGMP Snooping is operationally disabled on
it, IGMP Snooping Querier functionality is disabled on that VLAN. IGMP Snooping functionality
is re-enabled if IGMP Snooping is operational on the VLAN.
The IGMP Snooping Querier application supports the following activities:
•
Sends periodic general queries on the VLAN to solicit membership reports
Syntax
ip igmp snooping querier [vlan-id [address ipv4_address]]
no igmp snooping querier [vlan-id [address]]
•
vlan-id—A valid VLAN number.
•
ipv4_address—An IPv4 address.
Default Configuration
IGMP snooping querier is disabled by default.
Command Mode
Global Configuration mode
VLAN Configuration mode
User Guidelines
This command has no user guidelines.