Cardinal Industries 225 WEIGHT INDICATOR - Manual (Page 94)

PRESET WEIGHT COMPARATORS OPERATION
etup of
XX
X 10. P=XXXXXX 16. P=XXXXXX
The Model 225 indicator has sixteen (16) outputs, which can be configured during the s
PWC”. If the PWC feature was the weight indicator to perform as Preset Weight Comparators “
sele e
ct d during setup, the indicator will compare each enabled preset weight value with the
displayed weight and then output a signal for each preset based on the comparison results.
Enter Preset Values
14. With the indicator in normal operations mode, press the PRESET key.
1. P=XXXXXX 7. P=XXXXXX 13. P=XXXX
2. P=XXXXXX 8. P=XXXXXX 14. P=XXXXXX
3. P=XXXXXX 9. P=XXXXXX 15. P=XXXXXX
4. P=XXXXX
5. P=XXXXXX 11. P=XXXXXX 17. SET TRIM
6. P=XXXXXX 12. P=XXXXXX
ENTER to EXIT, or PWC# TO CHANGE: 0
PRESET
(PRESE 1. P=XXXXXX T 1 WEIGHT VALUE)
through
16. P=XXXXXX (PRESET 16 WEIGHT VALUE)
15. The display will change to show the 16 presets. Note that XXXXXX is the current value
d
values.
ct the PWC#
t
R
.
ENTER key to exit and return to
for each preset.
16. If the values displayed for each preset are acceptable, press the ENTER key to exit an
return to normal operation or press the 1 and 7 keys and then the ENTER key to enter
the preset trim weight
17. Otherwise, to change a preset weight value, use the numeric keys to sele
to change and then press the ENTER key. The display will change to show the curren
value of the preset selected.
18. Using the numeric keys, enter the new value for the preset and then press the ENTE
key to save the new setting.
19. Continue with this procedure until a value for each preset to be used has been entered
20. After the last preset value has been entered, press the
normal operation.
NOTE! Enter a zero (0) then press the ENTER key if the preset weight comparator is
not to be used.
8200-M538-O1
y 225 Installation
Page 90