Cardinal Industries 225 WEIGHT INDICATOR - Manual (Page 49)

CALIBRATION AND SETUP, CONT.
2
n.
key and then using the numeric keys, enter the
value for the printer parity rate and then press the ENTER key to save the new setting
and return to the COM1 SETUP
alues are 0, 1 or 2.
0 = NONE (No Parity) 1 = Odd Parity 2 = Even Parity
3. BITS ATA BITS)
With the COM1 SETUP MENU displayed the current setting for the BITS= parameter
will be the setting displayed is acceptable,
proceed to the next setup parameter.
NTER key and then using the numeric keys, enter the
M1 SETUP MENU Allowable values r 8.
4. STOP
With the COM1 SETUP MENU displayed the current setting for the STOPS=
parameter will be shown. Note that X is the current value. If the setting displayed is
accep
e next setup pa meter.
Otherw
using the numeric keys, enter the
value for the printer stop bits and then press the ENTER key to save the new setting
and return to the COM1 SETUP MENU. Allowable values are 1 or 2.
5.
is
cceptable, proceed to the next setup parameter.
the
ES
uous Output Enabled us Outpu
. PARITY=X XXXX (COM1 PARITY RATE)
With the COM1 SETUP MENU displayed the current setting for the PARITY=
parameter will be shown. Note that X is the current value and XXXX is the descriptio
If the setting displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 2 key, the ENTER
MENU. Allowable v
=X (COM1 D
shown. Note that X is the current value. If
Otherwise, press the 3 key, the E
value for the printer data bits and then press the ENTER key to save the new setting
and return to the CO
. are 7 o
S=X (COM1 STOP BITS)
table, proceed to th ra
ise, press the 4 key, the ENTER key and then
CONT=XXX (COM1 CONTINUOUS OUTPUT)
With the COM1 SETUP MENU displayed the current setting for the CONT= parameter
will be shown. Note that XXX is the current value. If the setting displayed
a
Otherwise, press the 5 key, the ENTER key, YES or NO (on the soft keys) and then
ENTER key to save the new setting and return to the COM1 SETUP MENU.
CONT=Y CONT=NO
Contin Continuo t Disabled
8200-M538-O1
y 225 Installation
Page 45