Cardinal Industries 225 WEIGHT INDICATOR - Manual (Page 40)

CALIBRATION AND SETUP, CONT.
2. NSC=XXX (AUSTRALIA NSC REQUIREMENTS)
NOTE! In countries requiring the 225 to meet Australia NSC requirements, the USA=
parameter must be set for international use ( USA=NO) to allow the 2. NSC=XXX
setup parameter selection.
With SETU NSC= parameter will be shown.
Note that X acceptable, proceed to the
next setup parameter.
Otherwise, press the
ENTER ke
ENU #1.
NSC=YES NSC=NO
NSC Requirements
Disabled
With SETUP MENU #1 displayed the current setting for the LFT= parameter will be shown.
Note that XXX is the current value d is acceptable, proceed to the
next setup
Otherwise
e ENTER ys) and then the
ENTER key to save the new setting and return to SETUP MENU #1.
LFT=YES LFT=NO
Interval Settings ( INTERVAL)
allowed are: 1, 2, 5, 10, 20, 50
Interval Setting ( INTERVAL) is
selectable from 1 to 99.
ta during input
CAP + 5% to OC
N nd USA=NO
YY
Z TRACK = 0.5
Z LIMIT = yes
CAP + 9 grads to OC
PT printed with tare
Lamp test on power up
P MENU #1 displayed the current setting for the
XX is the current value. If the setting displayed is
2 key, the ENTER key, YES or NO (on the soft keys) and then the
y to save the new setting and return to SETUP M
Australia NSC Requirements Australia
Enabled
3. LFT=XXX (LEGAL FOR TRADE)
. If the setting displaye
parameter.
, press the 3 key, th key, YES or NO (on the soft ke
NOTE! If LFT=YES and USA=YES NOTE! If LFT=NO
Division must be 100 to 10,000
Z TRACK = .5 or 0 to 3
Inhibit serial da Enables the Converted Units Net
Weight print feature
DATE = MM/DD/YY
Z LIMIT = NO
OTE! If LFT=YES a
STABLE = 1
DATE = DD/MM/
8200-M538-O1
y 225 Installation
Page 36