Cardinal Industries 225 WEIGHT INDICATOR - Manual (Page 48)

CALIBRATION AND SETUP, CONT.
8200-M538-O1
y 225 Installation
Page 44
The foll
Althoug
same s
tup menus shown and parameters described,
COM1 (Serial Port 1) is referenced. OM port number you are
owing describes the setup for the 225 COM ports (Serial Ports).
h the three (3) COM ports can be configured differently, they have the
etup parameters. In the se
Substitute the C
configuring for the number shown.
Serial Menu
1. PRINTER
2. COM1
3. COM2
4. COM3
Enter Selection: 0 ^ EXIT
. COM1
With the Serial Menu displayed, press the key and then the key to proceed to the
(COM1, SERIAL PORT 1) 2
2 ENTER
COM1 SETUP MENU.
COM1 SETUP MENU
1. BAUD=X XXXXXX 6. TYPE=X XXXXXXXXXX
2. PARITY=X XXXX 7. SCALE=0
3. BITS=
4. STOPS=X
5. CONT=XXX
Enter Selection: 0 ^ EXIT
1.
eter
will be shown. Note that X is the current value and XXXXXX is the actual baud rate. If
the se
Otherwise, press the 1 key, the ENTER key and then using the numeric keys, enter the
value for the printer port baud rate and then press the ENTER key to save the new
setting and return to the COM1 SETUP MENU. Allowable values are 0 through 13.
13 = 230400
2 = 1200 6 = 14400 10 = 57600
3 = 2400 7 = 19200 11 = 76000
BAUD=X XXXXXX (COM1 BAUD RATE)
With the COM1 SETUP MENU displayed the current setting for the BAUD= param
tting displayed is acceptable, proceed to the next setup parameter.
0 = 300 4 = 4800 8 = 28800 12 = 115200
1 = 600 5 = 9600 9 = 38400