Cardinal Industries 225 WEIGHT INDICATOR - Manual (Page 87)

ID STORAGE OPERATION, CONT.
ermanent Identification (ID) Strings
anent ID Strings
ress the MEM key. The display will
2.
3.
4.
5. e stored.
ER key and proceed to the next step.
e
7. ID
8. c
9.
o Edit A Permanent ID Strings
indicator in normal operations mode, press the MEM key. The display will
2.
3.
4. ng
5.
6.
and proceed to the next
step. Otherwise, using the numeric keys, enter the correct tare weight and then press
the ENTER key or to use the current scale weight for the tare, press the GROSS key
and then the ENTER key.
7. The display will change to show the current value for the accumulator associated with
the ID string.
8. If the displayed value is correct, press the ENTER key to save it. Otherwise, using the
numeric keys, enter the correct value and then press the ENTER key to save it.
9. The indicator will return to normal operation.
The following describes the ID Storage operation for the 225 with the ID Count set for
one prompt. Therefore only one prompt name is referenced. Substitute the prompt
name entered during ID Storage Setup for the prompt name shown. Note that w
ID Count set for more than one prompt, additional steps will be displayed.
ith the
P
To Add A Perm
1. With the indicator in normal operations mode, p
change to show Id=.
Enter up to a 12 digit alpha-numeric ID string and press the ENTER key.
The display will show
ReF=.
Using the alpha-numeric keys enter up to 12 characters for the name and then press
the ENTER key.
The display will change to show a zero tare weight valu
6. If a zero tare weight is correct, press the ENT
Otherwise, using the numeric keys, enter the tare weight and then press the ENTER
key or to use the current scale weight for the tare, press the GROSS key and then th
ENTER key.
The display will change to show a zero value for the accumulator associated with the
string.
If a zero value is correct, press the ENTER key to save it. Otherwise, using the numeri
keys, enter the accumulator value and then press the ENTER key to save it.
The indicator will return to normal operation.
T
1. With the
change to show Id=.
Enter the ID string and press the ENTER key.
The display will show
ReF=XXXXXXXXXXXX. Note that XXXXXXXXXXXX is the
name associated with the ID
If the name displayed is acceptable, press the ENTER key to save it. Otherwise, usi
the alpha-numeric keys enter up to 12 characters for the name and then press the
ENTER key.
The display will change to show the current tare weight stored.
If the displayed tare weight is correct, press the ENTER key
8200-M538-O1
y 225 Installation
Page 83