Cardinal Industries 225 WEIGHT INDICATOR - Manual (Page 106)

I
ort is standard on the Model 225 Indicator. The IR port is located on the
key (see Figure
The IR por r
the same s m
PRINTER
To use the
, you nee
y A computer (such as a desktop or laptop)
or a Personal Digital Assistant (PDA)
equipped with an IR port.
y An infrared port drive
computer or PDA to communicate with IR
port in the 225.
y App n software
PDA end and rec
USING THE IR PORT
1. Make sure the 225 is on and the computer or PDA is ready to communicate.
2. Align computer w
3. Ens t the ports 15º angle
to either the left or right and above and below.
4. Sen ommand
5. The 225 will perform the command (e.g. cha t weight on the
display) or the data requested will be sent to the computer or PDA.
NFRARED (IR) DATA PORT
An infrared (IR) data p
front panel of the indicator slightly above and to the right side of the PRINT
o. 14). NOTE! If not using the IR data port, it is highly recommended to disable it. N
t transmits and
ettings and for
eceives data using
ats supported by the
port.
IR port d the following:
r that allows the
licatio
to s
for the computer or
eive the data.
Figure No. 14
the ithin 3 feet (1 meter) of the IR port.
are facing each other (line-of-sight) with no more than a ure tha
d the c to the 225.
nge from Gross to Ne
Infrared
Port
8200-M538-O1
y 225 Installation
Page 102